VIPA II Body Protector for Jockeys (lightweight)

SKU: vipa-2-jockey
VIPA II Body Protector for Jockeys (lightweight)
 Back to: Vests for Safety
The VIPA II Jockey Body Protector is designed for both female and male riders. This body protector is specially made using shock-absorbing foam rubber and shock absorbing foam EPP for its lightweight.
The VIPA II Body Protector has been approved by the Australian Racing (AR).
The VIPA II Body Protector has been tested according to and conforms with, EN13158: 2018 Standard Level 2. 
The VIPA II Body Protector is constructed using Air Mesh, a lightweight material chosen for its strength, that allows for ventilation. The EPP shock-absorbing foam is specially designed to absorb impact when needed.  Air holes give extra airflow and ventilation for rider comfort.
Hand wash in lukewarm water. Add a few drops of mild detergent and gently swirl. Rinse. Hang on a coat hanger in the shade and leave to drip dry. Do not store until completely dry, this may take some time in colder weather.
The VIPA I Body Protector is available in Black.

REGULAR           LONG

X-SMALL 67-75cm  65-73cm 39cm 42cm 553g
SMALL 76-86cm 75-82cm 44cm 47cm 673g
MEDIUM 86-95cm 84-89cm 47cm 49.5cm 794g
LARGE 96-104cm 93-98cm 52cm 54.5cm 905g

Sizing charts are a guide

It is worth nothing particularly for Ladies, body protectors can fit larger than the chest range in the size chart suggests. As a general rule, we suggest that if the chest measurement is within the bottom half of the chest range indicated on the size chart, then drop down a size.

vipa safety vest size guide

VIPA Body Protectors are sold throughout the world and are well received by horse riders.  There are a few different standards used throughout the world for testing body protectors. VIPA Body Protectors are manufactured to the  EN13158: 2009standard and are tested to meet the highest safety requirements for the different disciplines for which they serve.  The EN13158: 2009 Standard provides the technical specification for equestrian body protectors, setting the level of shock absorption required to be offered and controlling the area of the body that must be covered by the protector.
There are three levels of protection to cater for different activities and users.  The highest Level 3 is tested at the highest energy impacts.  The materials used absorb impact thereby lessening or reducing the injury.  The differences between the three levels are due to the differing thicknesses of the foam used.
VIPA Body Protectors – VIPAVIPA IVIPA II (Harness and Carriage Drivers Only) and VIPA III are all tested and conform to the EN13158: 2009 Standard.   The VIPA Body Protectors are annually re-tested to ensure long-term consistency in the quality of the manufacturer and of the shock absorbing foam used in the construction of the body protectors.
No body protector can prevent serious injury in serious accidents, but a body protector can improve your chances of staying safe and reducing the severity of injuries by making the right choice. Injuries will not be prevented involving a severe extension, flexion, torsion or crushing of the body.  Spinal protection is not provided.
Frequent visual inspection should be made for signs of wear, especially after accidents or injury.  This may cause cell damage of the foam, obvious signs of which would be reduced thickness or a change of the feel of the foam.  The garment should be replaced if you are in any doubt.  Otherwise, under normal conditions, it is recommended that your VIPA Body Protector is replaced every 3 - 4 years.